Open Table of Contents

Target layer: Depending on the command

Description:  The ET Commands menu contains several commands which in general duplicate some of the functions available in the tools. The only difference is that the commands perform the corresponding function on the current selection. The commands are made available for users who prefer to make the selection first and then process the features. Note that the Hot Keys for adjusting the parameters for each function are not available with the commands - they have to be set in the ET GeoTools Control Panel before performing the operation. 

• ET Build Polygons (Target layer - Polygon) - this is the only command that is not available as a tool. The reason for this is that in most of the cases the source polylines must be carefully selected before proceeding with the Build Polygon function. See Build Polygons Command topic for a detailed description.
• ET Clean Overlaps (Target layer - Polygon) - see Clean Overlaps Tools
• ET Copy From Layer (Target layer - Polyline, Polygon) - see Copy features from other layer Tool
• ET Explode Selected (Target layer - Polyline, Polygon) - see Explode Tool
• ET Flip Selected (Target layer - Polyline) - see Flip Polylines Tool 
• ET Intersect Selected (Target layer - Polyline) - see Intersect Polylines Tool 
• ET Remove Duplicates (Target layer - Polyline) - see Remove Duplicate Polylines Tool 
• ET Generalize Selected (Target layer - Polyline) - see Generalize Densify Polyline Tools
• ET Densify Selected (Target layer - Polyline) - see Generalize Densify Polyline Tools
• ET Smooth Bezier (Target layer - Polyline) - see Smooth Polyline Tools
• ET Smooth B-Spline (Target layer - Polyline) - see Smooth Polyline Tools
• ET Smooth T-Spline  (Target layer - Polyline) - see Smooth Polyline Tools
• ET Clean Polylines Command  (Target layer - Polyline)
• ET Clean Polygons Command  (Target layer - Polygon)
• Validate Edits (Target layer - Polyline, Polygon).

Note:  The Hot Keys for adjusting the parameters for each function are not available with the commands - they have to be set in the ET GeoTools Control Panel before performing the operation.